DOUGLAS MACHINE THERMOFORMED HANDLING BUCKET


Situation

Douglas Machine needed a set of plastic components for a food packaging machine to properly guide product loading into flexible packaging. The part design was fit for thermoformed ABS, a process and material appropriate for rigid, industrial plastic parts that are not a full enclosure.

Complication

The parts required tight angle tolerances, and this was further complicated by lack of structure on the part to lock the angle dimension in place, particularly after the parts were machined on Gemstar’s 5 axis router. Thermoformed parts carry inherent stress, since they are heat formed from an extruded flat piece of plastic. After forming, the material can still have a tendency to flex back towards that original flat sheet, especially when machining removes some of the originally formed material.

A standard thermoformed tool design didn’t do the job. The parts off of standard male and female tools varied beyond what was acceptable.

Solution

The ultimate solution was a modular tool on which the Gemstar team could adjust the angle each run, based upon how the material was forming from lot to lot. Stringent quality checks were also put in place both post-forming and post-machining to ensure continued conforming product.

Results

Gemstar’s tenacious and precise plastic solution oriented thinking allowed the team to
produce precise plastic parts that met the customer’s specifications.
We were able to achieve:

  • Tighter tolerances than the industry standard
  • Proactive quality control procedures resulting in consistent plastic parts
  • Innovative tooling construction for modular adjustments

“This was a difficult project, especially when holding the tight tolerances required. Gemstar was able to exceed our demands. Douglas appreciated the engineering and bi-weekly communication Gemstar put into this project to make it successful.”
Darla Engstrom, Buyer, Douglas Machine